Creality K1 Max Ultraflat Bed Bed Finish:Ultraflat (Flat to 0.1mm)

Creality K1 Max Ultraflat Bed Bed Finish:Ultraflat (Flat to 0.1mm)The Creality K1 Max bed is machined out of 6mm thick 5083 Aluminum Cast Tooling plate. There are 2 3mm holes on the back edge for additional bed leveling. Weight: 4 lbs (approx) Length: 310mm Height: 315mm Thickness: 6mm All of our K1 Max beds are Ultraflat! Which is + 0. 05mm, or in plain terms, no more than 0. 1mm out of flat. The question has been asked about how flat our beds are after heating to 100C. The answer is that it depends on how you

16KG) ISO 1133 TBD Mechanical Properties Test Methodology Values Tensile Strength ISO 527 TBD Elongation at break ISO 527 TBD Flexural Modulus ISO 527 TBD Flexural Strength ISO 178 TBD Impact Strength ISO 180 TBD Thermal Dynamic Properties Test Methodology Values HDT@ 0

The Jubilee Yokes were designed by Mandala Rose Works

The 7th picture contains the information on the offsets of the Rear Mounted BLTouch from the nozzle

Please check the URL below for information

(This listing is for the PEI only

if you have a fan shroud for the printed carriage

tighten it 1/32nd of a turn and NO MORE

DO NOT use locktite

Just choose the side of the wrench that matches your hotend orientation

or use the nuts provided in the kit from Ratrig

slide it to a different position

These new mounts now have channels in them similar to the LDO STLs to support AWD setups